IT-200A Advanced Analog/Electronic Training System

Experiments Included:

  • Application of Ohm’s Law
  • Series DC Circuit
  • Parallel DC Circuit
  • Diode Characteristics
  • Characteristics and Applications of Zener Diode
  • Diode in a DC Circuit
  • Half Wave Rectifier Circuit
  • Full Wave Rectifier Circuits with Center Tapped
  • Bridge Rectifier Circuits
  • Voltage Doubler Circuit
  • Characteristics of Light Emitting Diodes
  • Characteristics of Bipolar Junction Transistor
  • Characteristics of Field-Effect Transistor (FET)
  • Characteristics of Unijunction Transistor (UJT)
  • Characteristics of Programmable Unijunction Transistors (PUT)
  • Characteristics of Silicon Controlled Rectifier (SCR)
  • Characteristics of DIAC
  • Characteristics of TRIAC
  • Non-Inverting Amplifier Circuit
  • Inverting Amplifier Circuit
  • Differential Amplifier Circuit
  • Integrator Circuit
  • Differentiator Circuit
  • Low-Pass Filter Circuit
  • High-Pass Filter Circuit
  • Band-Pass Filter Circuit

Description

IT-200A Advanced Analog / Electronic Trainer is a low cost Electronic teaching system. It is designed to provide all the tools necessary to conduct experiments related to Electronics Technology. It is also ideally suited for developing, debugging, integrating and testing systems.

Features:

  • Bread Board Based
  • Power Supplies Included
  • Basic Measuring Instruments Included
  • Flexibility to Perform Custom Experiments
  • Standard Function Generator Included
  • Standard Frequency Counter Included
  • Protection Circuits Included

Technical Features:

Function Generator:

Output Waveform:

  • Sine, Square, Triangle and TTL

Output Frequency:

  • up to 100KHz in five steps
  • Variable frequency control
  • Variable Gain control
  • Variable Offset control
  • Output voltage adjustable to 5V p-p

Universal Counter:

  • Frequency range: 1Hz~50MHz
  • Input signal: TTL or CMOS level or any level.
  • Display: 4 digit 7-segment LED display.

Supplies:

  • FIX Supply DC: +5V DC, +12V DC, -12V DC with short circuit protection
  • Variable Supply DC: 0 ~ +25V DC, 0 ~ -25V DC with short circuit protection
  • FIX Supply AC: 2V-0-2V, 12V-0-12V, 15V-0-15V with fused protection

3 ½-Digit Digital Voltmeter/Ammeter:

  • DC Voltage Range: 200mV, 2V, 20V, 200V
  • DC Current Range: 0 ~ 2A, Fuse Protected

Audio Output:

  • 0.5W Speaker with audio amplifier and volume control

Logic Indicator/State Monitor:

  • 4x 3mm LED’s

Switches:

  • 2 x SPST switches, 2 x DPDT switches, 1 x 2P6T switch

Interface Connector:

  • 2 x BNC connectors interfaced to 2mm gold plated pins
  • 2 x Banana connectors interfaced to 2mm gold plated pins

Solderless Breadboard:

  • 2 Terminal Strips, Tie-point 1680
  • 4 Distribution Strips, Tie-point 400

Accessories: 2mm-1mm patch cords, Power Cord, User Manual