Experiments:

  • Fundamentals of Electro-pneumatics
  • Piece drilling methods
  • Operating an electro valve
  • Operating a set of automated sensors
  • Operating a 12 Vdc motor
  • Operating a pneumatic cylinder
  • PLC control
  • Microprocessor control
    Recommended control modules (not included):
    Arduino training panel IT-1300A
    Programmable Logic Control Trainer (Siemens Based) IT-1200S
    Programmable Logic Control Trainer (Siemens Based) IT-1200S-40
    Programmable Logic Control Trainer (Fatek Based) IT-FBs-24MA
    Programmable Logic Control Trainer (Fatek Based) IT-FBs-40MA
    Programmable Logic Control Trainer (Siemens Based) IT-1500S

The IT-5116 is a drilling station It consists of a column drill fixed on a pneumatic skid moving it up and down. The piece to be drilled is installed on a support attached to a piston During the piece reception phase the base is pushed outside while during the drilling phase it is withdrawn under the drill The module is assembled on a rigid Bakelite base and it can be easily moved around the laboratory. IT-5116 can be fully controlled using a PLC module or an Arduino microprocessor Thanks to the PLC or Arduino programming software a wide range of exercises regarding the automation of the module in a working cycle or in stand-alone mode can be developed.